2-2
PanelMate ControlNet Communication Driver Manual
Hardware Layout
Below is a graphic representation of the end view of the ControlNet interface card.
J3 J2
SW1
4 2
3 1
The top set of stacked LED's are used to monitor UCS and network specific status. The bottom set of
stacked LED's are used to monitor redundant ControlNet channel status. See the table below for a more
detailed description of each component.
Item
Description
1
ControlNet Interface Status
2
Network Specific Status
3
Channel B Status
4
Channel A Status
J2
ControlNet Channel A BNC Connector
J3
ControlNet Channel B BNC Connector
SW1
ControlNet Addressing Switches
See following table for address settings.
Summary of Contents for EATON PanelMate ControlNet
