Cutera truSculpt, Operator'S Manual, Page: 13 / 66

5
TRUSCULPT OPERATOR MANUAL
D1395, REV. K, 02/18
System Installation
The truSculpt is shipped directly from the factory to your site. It is important that your staff be experienced
with the appropriate performance and safety considerations. Training associated with the system and
handpieces is available. Contact Cutera for information.
Remove the components from the shipping crate, and verify that all items have been received and are
not damaged. Save all containers and packaging material; they will be required if it is necessary to return
the equipment.
To set up the system you will need to:
• connect the RF handpiece
• connect the neutral electrode cable
• connect the main power cable
• insert the key
• fill the coolant reservoir
Refer to the following sections for detailed system installation instructions.
Connecting the RF Handpiece
Only one RF handpiece can be connected to the console at a time. Store the unused handpiece(s) in the
appropriate case.
NOTE
Do not remove the protective tape covering the two USB ports
(behind the keyswitch). The USB ports are for service use only, and
only Cutera Service personnel shall remove the protective tape.
WARNING
Before connecting the handpiece, inspect the handpiece housing,
umbilical cable, umbilical connector, and RF electrode for dirt,
debris, or damage. Ensure that the pins inside the umbilical
connector are not damaged, bent, or recessed.
WARNING
Never disconnect the RF handpiece while the system is turned on.
Damage to the power supply may occur. Always turn off the system
and wait for approximately 30 seconds before disconnecting the
handpiece.