Custom Audio Electronics STIMARE STIMA-SML, User Manual

Page: 36 / 86

USB MASS STORAGE Sharing mode from Mass Storage:
Disabled D = sharing mode disabled
Enabled = sharing mode enabled
USB ADDRESS NUMBER
Numerical address code for the univocal identiication of the USB device (in case of more
than a USB device connected with the same PC):
0 D 2 4 6 8
1 3 5 7 9
USB VIRTUAL COM Setting the USB port as a virtual serial port:
Disabled D = Virtual COM disabled
Enabled = Virtual COM enabled
NOTE: To use this coniguration it is necessary to install an additional driver.
PRINT MODE Printing mode:
Normal
D
= enables printing in normal writing way
Reverse = enables printing rotated 180 degrees
AUTOFEED Setting of the Carriage Return character:
CR disabled
D
= Carriage Return disabled
CR enabled = Carriage Return enabled
NOTE: The parameter is printed only with CUSTOM/POS emulation enabled.
CODE TABLE [num]
Identiier number of the character code table to use.
The numeric value of the identiier is made up with the following two parameters for the
setting of two digits for the tens and the units:
CODE TABLE [num x 10]
Setting the digit for tens:
0 D 2 4
1 3 5
CODE TABLE [num x 1]
Setting the digit for units:
0 D 2 4 6 8
1 3 5 7 9
NOTE:
See the par.7.7 to learn about the character tables corresponding to the identiication numbers set with this
parameter.
The character tables set with this parameter are the same set with the command 0x1B 0x74 (refer to the
Commands Manual of the device).
36
CUSTOM-Powered