Custom Audio Electronics KPM302III, User Manual

Page: 98 / 188

PRINT DENSITY Adjusting the printing density:
-25% 0 D +25%
-12% +12%
The print quality is strongly inluenced by the type of chemical treatment and the type of
storage to which the thermal paper has been subjected, as well as by the weight of the
same. It may therefore necessary to act on this parameter to obtain the desired print quality.
TICKET LOCKING This parameter enables/disables the block of the paper inside the device where the ticket
is not cut with the autocutter, but is presented for the manual tear of by the user:
KPM302III, KPM303III, KPM302III EJ, KPM303III EJ, KPM302III vSEL, KPM303III vSEL,
TK302III, TK303III
Disabled D = paper block disabled
Enabled = paper block enabled
KPM302III TF, KPM302III TF-EJ, KPM302III TF-vSEL, KPM302III TF-hSEL
TK302III TF
Disabled D = paper block disabled
By Printer = the motor remail switched on also at the printing end
By Feeder = stops the paper of the not active (idle) feeders in order to avoid that the
paper parked in an idle feeder, is dragger inside the printer
Complete = ticket locking by printer and feeder (combination of the two previous ef-
fects)
If parameter "Black mark position" is set on "Disabled", this parameter has no efect on
device coniguration and it is not printed on setup report.
TICKET MANAGEMENT This parameter allows the ticket management:
Disabled
D
= no check
Short Ticket = it is possible to manage tickets with length less than the distance between
black mark sensor and printing line
Check First = before printing, the device checks the integrity of the irst ticket
Stub+Ticket = it is possible to manage tickets with stub
EJECTOR SPEED Set the speed of the ejector device:
25% 75%
50% 100%
D
This parameter is valid only for models with the ejector device.
EJECTOR TYPE Management of the ejector device:
Presenter = after the printing end, the device cuts the ticket and holds it between the
ejector rollers waiting for the user withdrawal
Ejector
D
= after the printing end, the device cut the ticket and eject it
This parameter is valid only for models with the ejector device.
98