Curtiss-Wright KAD/ADC/129/S2, Manual, Page: 4 / 12

KAD/ADC/129/S2
4
1 Jun. 2021 | DST/V/081
CURTISSWRIGHT.COM
Filter delay – 200 – µs Where f
in
= f
c
= 10kHz (f
in
: input signal frequency).
Input resistance
between inputs 10 – – MΩ Whether module powered on or off.
single ended input to GND – 34.8 – kΩ Module powered on Measured on ANALOG(x)- input.
single ended input to GND 43 52 – kΩ Module powered off. Measured on ANALOG(x)- input.
single ended input to GND 10 – – MΩ Whether module powered on or off. Measured on
ANALOG(x)+ input.
Input impedance
between inputs – 300 – kΩ Module powered on (measured at 3kHz).
single ended input to GND – 300 – kΩ Module powered on (measured at 3kHz).
TABLE 3 Bipolar DC voltage excitation outputs
PARAMETER MIN. TYP. MAX. UNITS CONDITION/DETAILS
Outputs – – 4 – Applied per channel.
Output voltage
operating range 0 – 5.1 V Bi-polar excitation: 5V is 10V across the bridge.
resolution – 1.8 – mV Bi-polar excitation: 1.8mV is 3.6mV across the bridge.
compliance – – 30 mA Per channel.
short circuit current – – 125 mA
short circuit duration ∞ – – s
DC error
error – 0.1 0.3 %FSR With a constant 350Ω load.
noise (gain = 1) – – 0.5 mV
rms
As measured on analog input.
noise (gain = 10) – – 0.05 mV
rms
As measured on analog input.
noise (gain = 100, 1000) – – 0.01 mV
rms
As measured on analog input.
Output resistance – 0.2 – Ω
TABLE 2 Differential ended analog inputs (continued)
PARAMETER MIN. TYP. MAX. UNITS CONDITION/DETAILS