Curtiss-Wright FHB5-PE1MWB04-00, User Manual, Page: 66 / 72

10-8
FibreXtreme User Guide
APPENDIX D
Copyright 2017
10.5 Parallel FPDP Signal Timing
Figure 8-2 shows the timing for several FPDP interface signals. This figure is accurate for all four
data framing types. See section 8.3.2 for a discussion of framing. The Data Valid signal, /
DVALID, is asserted by the FPDP-TM when valid data is transmitted onto the FPDP bus but not
before at least 16 STROBE periods have occurred. The FPDP-TM must de-assert /DVALID
when no more data remains in its buffer until valid data is again available. To avoid losing data
when the receiver’s FIFO is almost full, the receiver (FPDP-RM or FPDP-R) must assert the /
SUSPEND signal to hold off the transmitter. The FPDP-TM must de-assert /DVALID within 16
STROBE periods and keep it de-asserted until /SUSPEND is de-asserted. Per the FPDP
specification, after /SUSPEND is de-asserted, the FPDP-TM must wait for at least one STROBE
period before re-asserting /DVALID. With the FibreXtreme SL240 PCIe card, after /SUSPEND
is de-asserted, the FPDP-TM must wait for at least two STROBE periods before re-asserting /
DVALID. The /SUSPEND signal is asynchronous to the STROBE clock and should be double
synchronized by the FPDP-TM before being used in order to avoid metastability problems.
The FPDP-TM must not transmit data onto the FPDP bus until the Not Ready signal, /NRDY, is
de-asserted by the FPDP-RM and FPDP-R devices. The FPDP-RM and FPDP-R devices must
assert /NRDY when they are not ready to accept data and must de-assert /NRDY otherwise. The
/NRDY signal is asynchronous to the STROBE clock and should be double synchronized by the
FPDP-TM before being used in order to avoid metastability problems.
As required by the Front Panel Data Port Specifications, ANSI/VITA 17-1998, the FPDP-TM
transmits the Data Direction signal /DIR.FPDP-RM and FPDP-R devices may receive /DIR. The
/DIR signal is not given a firm definition of use. Possible uses of this signal include providing a
status indication available to be read by software or to allow operation to be inhibited until /DIR is
asserted. The /DIR signal may be asynchronous with other FPDP signals. An SL240 PCIe
FPDP-R or FPDP-RM inverts and passes this signal from the FPDP interface to the link
interface. DIR is an active-high signal on the link interface. /DIR is an active-low signal on the
FPDP interface.
Two user-defined Programmable I/O (PIO) signals, PIO1 and PIO2, are reserved in the Front
Panel Data Port Specifications . These are auxiliary signals, and are not required for core FPDP
functions. However, these signals can be user-defined to allow the FPDP-TM, FPDP-RM, and
FPDP-R devices to transfer information that is not part of the FPDP specifications. The FPDP-
TM, FPDP-RM, and FPDP-R devices must not drive either of the PIO lines immediately at
power up of the system. This is to avoid the possibility of two devices driving the same PIO line
simultaneously and causing damage to the driver device.