WATER BOILER - WB-10 -12
INSTALLATION INSTRUCTIONS
1. Unpack equipment carefully, inspect for any freight damage. Be sure to promptly
put a claim into the freight company if any damage is found.
2. Connect faucet securely to the faucet adapter.
Electrical and plumbing hook-ups should be made by authorized installers only.
INSTALLATION MUST COMPLY WITH ALL NATIONAL AND LOCAL ELECTRICAL AND
PLUMBING CODES.
3. This water boiler can operate on 120, 208 or 220 volt power supply. To ground equip-
ment, connect the ground wire to the green screw on inside bottom of wrap.
4. This boiler comes wired for 208 or 220 volt, single phase, 3 wire plus ground, see wiring
diagram.
5. To connect the water boiler for 120 volt operation:
A. The facility will have two wires, one WHITE (neutral) and the other BLACK. Plus
GREEN for ground.
B. Splice the BLACK wire from power source, to both the heavy RED (#10 AWG) and
thin BLACK (#18 AWG) wires from the WB-10.
C. Take the WHITE wire from the facility power source and splice it to the BLUE wire
(#10 AWG) and WHITE wire (#18 AWG) from the machine (see wiring diagram).
6. Water Hook-Up: Use a 1/4" copper line with a female flare fitting. Water inlet fitting is
located on the back of the WB-10.
CAUTION
Before
turning thermostat dial to ON position, fill equipment with water up
to the probe tip. This will prevent heating elements from burning out.
1
