Curtis RCD744, Instruction Manual

Page: 12 / 14

This continues until all the tracks have been played on that disk, the unit will then enter the
STOP mode.
It is possible to program, the tracks you wish to play in a sequence of your choice, it is not po-
ssible to enter programs during disc play. Press the STOP Button first, and then follow the inst-
ructions below.
ENTERING A MEMORY
1.Press the MEMORY Button. The information will be displayed on the display.
2.Select the desired track using the Forward and Reverse SKIP/SEARCH Buttons.
3.Press the MEMORY Button.
The first program selection is now stored in program memory.
4.Select the next desired track using the Forward and Reverse SKIP/SEARCH Buttons.
5.Press the MEMORY Button.
Continue entering tracks in this way until all the desired tracks are stored (up to 20).
Notes: If the Button is pressed before the MEMORY Button is pressed to store a track,
the track will not be programmed, and the disc will start playing from the first selected track.
Any track can be programmed to play more than once.
Repeatedly pressing the MEMORY button will enable you to check the program if required
LISTENING TO MEMORY TRACKS
1. Enter all tracks you want to program into memory following the procedure above.
2. Press the Button.
3. Disc play will start at the beginning of the first programmed track.
TO CLEAR THE PROGRAM MEMORY
If the disc is playing, press the STOP Button. The MEMORY will disappears.
The program memory will also be cleared if the disc compartment is opened, if the function is changed,
or if the power is switched off.
SLEEP FUNCTION
When the disc is playing,press SLEEP button on the remote control.SLEEP and 90 indicators will appear.
Press and hold SLEEP button to select the time you want (max 90, min 10). Then the unit will resume
playing mode, but SLEEP will display on the screen. And the unit will change to standby mode at the
preset time. For example, you select 10 by SLEEP button; the unit will change to standby mode after 10
minutes.
TIMER ON FUNCTION
The unit incorporation a Timer function to allow it to be switched ON from standyby into either CD Tape
or Tuner Mode.
If CD mode is selected the unit will switch ON and start playback from the first track of the loaded disc.
If Tape mode is selected the play button on the tape must be remain pressed down for playback to start-
This mode is not recommended for long periods as damage to the tape may occur.
If Tuner mode is selected the last listened to station will be heard when the unit switches on.