Curtis RCD744, Instruction Manual

Page: 8 / 14

LISTENING TO THE RADIO
OPERATION
Press the STANDBY/ON button to turn the unit on.
Select the Tuner function by pressing the TUNER button.
Select the desired frequency band that your station is on (FM, AM) with the BAND Selector button on
the unit .
Tune to the desired radio station by pressing the TUNING UP/DOWN buttons on the unit or on the
remote control.
If you hold the TUNING UP/DOWN button for more than half a second ,the unit will begin to automatic-
ally scan until a strong signal is found or until the TUNING UP/DOWN button is Pressed again.
To turn off the radio, press the STANDBY/ON button to switch the unit into standby mode.
STORING PRESET STATIONS
Tune either automatically or manually (as described in previous sections) to the station to be stored.
Press the MEMORY / CLOCK button once; "MEMORY" will blink on the display. The display will change
for 5 seconds; during this time you must select the desired memory location by pressing theMEMORY
UP button.
Press the MEMORY / CLOCK Button to store the station at that location.
The unit can store up to 10 FM stations, 10 AM Stations.
TUNING TO A PRESET STATION
Select the desired program number by pressing the M-UP / REPEAT button
ANTENNA
There is a built-in one-meter FM Antenna wire at the rear of the unit.
Unravel the wire and move it around to obtain the best reception. For AM reception the signals are
picked up through the external frame antenna. You may have to move the frame amtenna to obtain the
best reception.
SELECTING A PRESET STATION
To select a preset station, press the M-UP Button on the unit until the desired preset program is
displayed.