SPRAYHEADS
: Mentioned in this Programming guide are the words Gray and Purple. This refers to the color of the sprayhead. The current
sprayhead is the purple AFS. The older version is the gray sprayhead. See the illustration at right.
PURPLE
GRAY
To Go Into Programming
Turn off (dark display) by pressing ON/OFF button (yellow). Press and
hold
BREW button 4 (green) and then press and release ON/OFF button (yellow).
Continue holding BREW button. Display will read
, wait until
is displayed Enter the 4-digit access code, the digits 1-4 corre
-
spond to the buttons (see illustration below).
The default code set at the factory is 1-2-3-4. Then
will be displayed.
PROGRAM MENUS
All programming selections are performed with the three center buttons.
The symbols below the buttons are:
Scroll LEFT
SELECTION or ENTER to save new parameter
Scroll RIGHT
4
3
1
2
Continued on Page 3
Service Manual – Tea Brewer
Your Curtis Generation 3 Brewer is Factory Pre-Set for Optimum Performance.
After connection to water and power; the rear toggle switch must be on. You will hear a beep sound, indicating power is available to the controller.
The control displays
. Press ON/OFF button and the screen will display
. After three seconds,
is displayed.
Water will fill the tank (approximately 2-3 minutes depending on water flow rate). When the proper level is reached
will appear on the
screen. It takes approximately 20 minutes to reach set point temperature of 204°F.
Control will display
when temperature reaches the set point (204°F). Unit is now ready to brew.
CURTIS
< TCT >
CURTIS
CURTIS
FILLING
CURTIS
HEATING
CURTIS
READY to BREW
Program Menus
Tea By Volume
Tea Recipes
Tea By Time
Program Menus
screen. Press > button, to show the next menu item.
Tea Recipes
(Factory set to Standard Tea Purple)
Press
to Select. Press < or > to scroll through recipes: Standard Gray, Standard Purple, Tropical Gray, Tropical
Purple, 76/308 Gray or 76/308 Purple. Press
to set.
Tea by Volume:
Press
to select, Display will now show Push START To Begin... Press the BREW button then
hot water starts running, when desired volume is reached press BREW button again to stop the flow. Now the
volume has been set. Pressing > button will display the subsequent menu features.
Tea by Time
(Factory set to 5:52)
Press
to select. By pressing < or > buttons, you can increase and decrease time. Press
to set minutes and
seconds.
Tea Dilution Delay
(Factory set to 0:30)
Press
to Select. Press < or > buttons, to add or decrease time. Press
to set.
Tea Dilution Volume:
Press
to Select, Display will now show Push START To Begin... Press the BREW button
and water will flow, when desired volume is reached press BREW button again to stop the flow. Now the volume
has been set. Press > to display subsequent menu features.
Dilution Time
(Factory set to 4:05)
Press
to Select. By pressing < or > buttons, you can increase and decrease time. Press
to set minutes and
seconds.
Tea Dilut Volume
Tea Dilut Delay
Tea Dilut Time
2
