Satellite WarmerS
adjuSting the temperature
gemini Warmers feature three temperature settings. Warmers are rated at 90W with high (100%); med
(60%); low (30%). pressing the Warmer button once will place it on high; a
second time med; third time lOW as indicated by the warmer lights. a fourth press of the
button turns the warmer OFF.
When the system is turned off at the On/OFF button, it will remember the last warmer setting.
additionally, if the warmer is OFF the gemini will automatically turn the warmer on (med Setting) when the
BreW button is pressed.
For optimum coffee quality, satellites should be pre-heated for 10 minutes prior to brewing.
Warmer Quality timer – Factory Set to diSaBled
gemini Systems feature a Quality timer which will sound an alarm and the corresponding warmer light will
blink advising you coffee should be replaced. Once the alarm sounds you can shut it off by pressing the
Warmer button. the Quality timer can be set from diSaBled (zero) to 200 minutes in 20 minute inter-
vals.
nOte: if main power is turned OFF or rear toggle Switch is switched to StandBy, the Warmer Quality timer
must be re-programmed.
to set, follow these instructions:
9
WARMER QUALITY TIMER – Factory Preset to DISABLED
To Determine Warmer Setting and Change Time for GEMINI Systems:
• WARMER MUST BE OFF. Press and
HOLD until the light turns ON, then goes OFF;
RELEASE.
• The light will start blinking. Count the
blinks. Each blink = 20 minutes (maximum 200 min.).
• At the end of the cycle, Press and HOLD
until the light begins QUICK Flashing. The cycle will
start over after 11 Flashes. (NOTE: A setting of 11 Flashes is the DISABLED Position).
• When the desired time is reached, RELEASE .
• To set and exit press
.
ON/OFF
WARMER
WARMER
WARMER