IMPORTANT:
Change the program settings only if necessary. Before programming, allow the brewer
to reach brewing temperature. Make sure air is purged from the lines according to the
INSTALLATION
INSTRUCTIONS
.
Programming Options
Changing the Brew Temperature (Factory Default: 200°F)
This function sets the tank water temperature.
1 If the control panel is lit, turn off power by pressing the ON/OFF button.
2 Press and hold the right BREW button. While holding the BREW button, press and release the ON/OFF button.
Continue holding the BREW button until the READY TO BREW light
starts
to blink, then release.
3 Press the right BREW button a second time, for two seconds, then release.
4 The READY TO BREW light with start blinking. Each blink equals 2°F, starting at 170°F.
5 To change the temperature setting, press and hold the right BREW button. The READY TO BREW light will
nBTIRVJDLMZ&BDInBTIJOEJDBUFTB¡'JODSFBTFJOUFNQFSBUVSF8IFOUIFUFNQFSBUVSFSFBDIFT¡'UIF
nBTIJOHXJMMQBVTFUIFOTUBSUPWFSBU¡'
6 When the desired temperature is reached, release the BREW button.
7
1SFTTUIF0/0''CVUUPOUPTBWFBOEFYJU
Changing the Brew Volume (Factory Default: 250 Seconds)
5IJTGVODUJPOTFUTUIFWPMVNFPGUIFCSFXDZDMF&BDITJEFDBOCFTFUJOEFQFOEFOUMZ
1 If the control panel is lit, turn off power by pressing the ON/OFF button.
2 Press and hold the right BREW button. While holding the BREW button, press and release the ON/OFF button.
Continue holding the BREW button until the READY TO BREW light
starts
to blink, then release.
3 Place an empty satellite under the brew basket on the appropriate side (left or right). Make sure it is pushed all
UIFXBZCBDLBHBJOTUUIFGSPOUDPWFS
WARNING:
Keep hands, arms and other items away from hot surfaces of the brewer during operation.
4 Press and hold
UIFBQQSPQSJBUF MFGUPSSJHIU#3&8CVUUPOVOUJMIPUXBUFSCFHJOTUPnPXJOUPUIFTBUFMMJUF
5
8IFOUIFEFTJSFECSFXWPMVNFJTSFBDIFESFMFBTFUIF#3&8CVUUPO
6
1SFTTUIF0/0''CVUUPOUPTBWFBOEFYJU
Viewing the Brew Cycle Counter
This function allows you to monitor the number brew cycles the brewer has performed for maintenance purposes.
1 If the control panel is lit, turn off power by pressing the ON/OFF button.
2 Press and hold the right BREW button. While holding the BREW button, press and the ON/OFF button.
Continue holding the BREW button until the READY TO BREW light
stops
blinking, then release.
3 The READY TO BREW light will start a pattern of short and long blinks. The blinks indicate the number of brew
cycles. The number of short blinks indicate the digit. The long blinks separate the 1’s, 10’s, 100’s, 1000’s and
10,000’s.
4
1SFTTUIF0/0''CVUUPOUPFYJU
PROGRAMMING GUIDE
PG7
WC-760, PROGRAMMING GUIDE
111116NC