Connect the Power Cord
28 For 220 Volt units, connect the power cable wires to
UIFUFSNJOBMTJOUIFKVODUJPOCPY0OCSFXFSTTFUVQGPS
120 Volts, connect the power cord to the appropriate
electrical outlet. See the
ELECTRICAL SCHEMATIC
for
the power supply requirements.
Power Up the Brewer
29 Turn on the water supply valve.
30 Make sure that the circuit breaker supplying power to
the circuit is on.
31 Turn the toggle switch on the back of the water tower
UPUIF0/QPTJUJPO5IFXBUFSUBOLXJMMTUBSUUPmMM8IJMF
UIFUBOLJTmMMJOHJOTQFDUUIFXBUFSTVQQMZMJOFGPSMFBLT
32 When the water in the tank rises to the correct level, the
heating elements will turn on automatically. Depending
on the incoming water temperature and the electrical
TQFDJmDBUJPOTUIFXBUFSUBOLUZQJDBMMZSFRVJSFT
minutes to reach the factory set operating temperature.
When the water has heated, “Ready to brew” will
appear on the LCD screen.
33 Perform a brew cycle of a least 12 ounces to purge
any remaining air from the system. See
OPERATING
INSTRUCTIONS
. During the initial brew cycle and
XIFOFWFSUIFmMUFSJTSFQMBDFEZPVNBZIFBSUIF
TPVOETPGBJSCFJOHQVSHFEGSPNUIFmMUFSUVCJOHBOE
water tank.
Installing the Optional Brew Basket Holder
34 Make sure the toggle switch on the back of the water
tower is in the off position.
35 Thread the shaft of the brew basket holder into the hole
(located toward the back) on the underside of one of
the brew heads. Hand tighten into place.
WARNING:
If using a 120 Volt power cord, connect
the power cord to the appropriate type and size
electrical outlet. If the electrical outlet is not
compatible with the power cord, have it upgraded
by a licensed electrician. Do not modify the power
QMVH %P OPU VTF BO FYUFOTJPO DPSE %P OPU VTF B
power cord/plug that is damaged.
IMPORTANT:
When operating the brewer at
higher elevations, reduce the factory set operating
temperature by 2°F for each 1000 feet of elevation
above 4000 feet. See
PROGRAMMING GUIDE
.
INSTALLATION INSTRUCTIONS
II12
SERA2, INSTALLATION INSTRUCTIONS
111617A