Install the Drip Tray
8 After preparing the drip tray location, according to Step
BQQMZ5FnPOQMVNCJOHUBQFUPUIFUISFBETPGUIF
supplied pipe nipple (or barbed elbow)* and thread
into the bottom of the drip tray. Assemble the drip tray
pieces as shown and place them into position.
*The elbow may only be used on drip tray installations
that are open wide enough on the bottom to allow
access to the barb connection.
9 Install the drain system. Be sure to allow room under the
countertop for the water tower.
INSTALLATION INSTRUCTIONS
II12
Inset frame, inset
installations only
Pipe
nipple
Barbed
elbow
Inset
cutout, inset
installations only
'UDLQKROHÀXVK
installations or fully
enclosed inset installations
Install the Brew Heads
Install the brew head assemblies into the countertop in the
correct position. One brew head is designed to be installed
on the right side and the other on the left. The installation
position for each brew head is marked on the attached
wires and tubes. Each brew head has three 1/4–20 studs
with matching nuts and washers for mounting onto the
surface of the counter.
10 Hold a brew head over the group of holes that matches
the markings on the brew head tubing/wiring (right or
left).
11 Insert the tubes and wires into the large center hole and
insert the studs through the three smaller holes, while
pushing the unit down onto the counter top.
12 Secure using one (1) fender washer, one (1) lock
washer and one (1) nut per threaded stud. Repeat for
the other brew head.
CAUTION:
Do not open the brew head units! The
MFOHUIPGUIFXJSFTBOEUVCJOHBSFmYFEBOETFUBUUIF
GBDUPSZ%POPUTQMJDFPSFYUFOEUIFUVCFTUIBUDPNF
from beneath the brew head assembly. Ample tube
length is provided and the tubes will need to be
shortened in most cases for proper installation.
Figure 5 - Drip Tray Installation
Figure 6 - Brew Head Installation
SERA2, INSTALLATION INSTRUCTIONS
111617A
