8
9
This appliance requires little maintenance. It contains no user serviceable parts. Do
not try to repair it yourself. Contact the customer service department for any unusual
issues you may experience.
1.
Always unplug Mini Multi Cooker before cleaning.
2.
To clean Housing, wipe down with a damp cloth and dry thoroughly.
Never submerge Housing in water or other liquids.
3.
To clean Removable Pot, wash in warm soapy water with soft sponge.
Dry thoroughly. Do not place in dishwasher.
4.
To remove and clean Lid Heat Shield, refer to page 9.
5.
Do not use abrasive cleaners.
6.
Store Mini Multi Cooker in a clean dry place.
7.
Contact Customer Service for any issues or malfunctions that should
occur.
When cool, pull the Lid Heat Shield off and wash with warm soapy water and soft
sponge. Using a damp cloth, wipe underside of lid, ensuring to wipe the Outer Lid Seal
gasket and Air Vent thoroughly (see Figure 2).
CARE & CLEANING
FIGURE 2
OUTER LID SEAL GASKET
LOCK PIN
AIR VENT
HEAT SHIELD PLUG
LID HEAT SHIELD
1.
Do not fill Removable Pot more than 3/4 full. Overfilling Pot can cause
liquids to overflow onto heating elements and clog Air Vents.
2.
To ensure foods are cooked within the provided cooking cycles, cut meats
and vegetables into bite sized pieces. Large pieces of food may need
multiple cooking cycles to cook.
3.
If cooking cycle ends before food has finished cooking, press and hold
Power Button for 3 seconds until flashing. Select desired function and
continue cooking.
4.
Cook food with lid closed to keep heat from escaping. If necessary to stir
occasionally in recipe, stir food and quickly close lid.
5.
For fluffier rice, rinse measured rice under running water until water runs
clear. This removes excess starches which results in a less sticky rice.
TIPS FOR BEST RESULTS
REMOVING AND CLEANING LID HEAT SHIELD
1. REMOVE HEAT SHIELD PLUG:
2. REMOVING LID HEAT SHIELD:
Pull out to remove.
To assemble, push lid
heat shield in till lock pin
protrudes through heat
shield plug and holds lid
heat shield in place.
Pull out/push in silicon plug.
Note: make sure the heat shield
plug is reinstalled in correct
position (see figure 2).
