3.2
MACHINE INSTALLATION (CONT'D)
3. Once the cable has been routed to the cab, reseal all drilled openings to prevent
moisture and/or exhaust gases from entering the cab.
MANUAL REMOTE CHOKE
:
4. Remove the cover from around the fuel shut-off, and choke levers. Doing this will
allow you access the choke cable mounting hole, on the choke lever. While facing the
“pull start” side of the engine, you will need to remove the bolt located at the top left side
of the engine shroud. You will also need to remove the top center bolt on the pull rope
(recoil) shroud. Insert the choke cable end into the small hole on choke lever. Secure
the choke cable assembly to the engine using the two clamps provided at the locations
where the two bolts were previously removed. Install the fuel shut-off, and choke lever
cover back onto the engine.
Note:
The
MANUAL REMOTE CHOKE CABLE
is provided for cold starting of the engine
from the vehicle cab. Once the engine has been allowed to warm-up, choking the
engine should not be needed for restarting.
Be careful not to have too many bends
When routing the choke cable assembly. Doing so will cause the cable to bind inside of
the cable casing and restrict its movement.
MANUAL REMOTE CHOKE KIT P/N 64659-1
11
ITEM QTY
P/N
DESCRIPTION
1
2
86690
CLAMP, TUBE, .25
2
1
64658-1 CABLE,CHOKE (FORMED)
