NEED ASSISTANCE?
•
844.278.4357
•
RA
•
PAGE 3
Step 5
With help, carefully place the running board
onto the mounting brackets.
Align the T-rails with the mounting brackets
on the vehicle. Slide the top mounting track on
the board over the top flange on each bracket.
Adjust the T-rails in the lower track of the
board so the studs drop into the slots on the
bottom of each mounting bracket.
Step 6
Secure the running board to the front mounting
bracket using one M8 flat washer and one
5/16" nylock nut on each T-rail stud.
Repeat for the middle mounting bracket.
Before securing the rear mounting bracket,
place an LED light bracket over one of the
T-rail studs, as shown in the third image.
Secure each T-rail stud with one M8
flat washer and one 5/16" nylock nut.
Snug the hardware, but do not fully tighten.
Step 7
At this time, adjust the running board
to the desired location.
With the running board in position,
it is recommended to tighten all
brackets to the vehicle first, followed
by the running board connections.
Repeat steps 1 through 7
on the passenger side.
