NEED ASSISTANCE?
•
844.278.4357
•
RA
•
PAGE 2
Step 1
Starting on the driver side, locate the three
mounting locations underneath the vehicle.
Step 2
Starting at the front driver-side mounting
location, remove two hole plugs.
Insert an M8 clip nut through the access
hole and align it over the adjacent smaller
hole. Insert a second clip nut over the lower
mounting tab.
Place the driver-side front mounting bracket
onto the vehicle and secure with two M8 hex
bolts, lock washers and flat washers.
Snug the hardware, but do not fully tighten.
Step 3
Repeat step 2 for the middle and rear brackets.
Step 4
With the driver-side brackets installed, take
the driver-side running board and insert three
T-rails into the slot as shown.
Note:
Position each T-rail as close to the
mounting bracket location as possible.
