Currys Essentials C510WMS13, Instruction Manual

Page: 10 / 28

INSTALLATION
10
˚C
˚C
˚C
˚C
Lingerie
Hose and Cable Lengths
How to connect from the left side
~80cm
~90cm
~130cm
~40cm
110 - 135cm
min. 60cm
max. 100cm
How to connect from the right side
Levelling the Washing Machine
There are 4 levelling feet on the underside. They must be adjusted to make sure the washing
machine is level.
1. On each stand, loosen the lock nut by turning it with a spanner.
2. Adjust all four feet in this way.
3. Use a spirit level to ensure the washing machine is level.
4. Tighten each lock nut by turning them again using a spanner.
Ensure all four lock nuts are tightened securely. Check the feet are still
bolted to the washing machine - if they’re unbolted, the washing machine
will move around.
Water Supply Hose
Points to remember
• Follow the instructions in this section to avoid water leaks.
• Don’t connect the hose to a combination tap.
• Don’t twist, squash, modify or cut the hose.
• Optimum water pressure in the main pipe is 0.05 MPa - 1.0 MPa. If the water pressure is
set higher than this, you will need to install a depressurising valve. Water-flow from the
tap should be more than 5 litres per minute. If you’re unsure, ask a qualified technician to
connect the hose.
• This unit must only be connected to cold water mains using the new water inlet hose
provided.
Connecting the Water Supply Hose
1. Attach the hose to a tap, and tighten
the plastic joint by hand.
2. Open the tap slowly and check that
there are no leaks around the joint.
Leak-proof System - Overflow Detection
3/4”
min. 10 mm
3/4”
min. 10 mm
Plastic joint
The joint is subject to water pressure.
lock nut