Step 2. Install Adjustable Tank Mount Arm Brackets
1.
Unpack both Tank Mount Arm Bracket boxes
, remove components and mounting hardware.
Each arm bracket should include the following:
1 x Aluminum arm w/bracket (pre-installed)
2 x Light fixture clip with screw and turn nut
4 x Bracket attachment screws
2.
Determine mounting location
on tank where
the arm bracket will be installed. Clean glass
of any algae or debris before installation.
3.
Determine bracket mounting height
to suspend fixtures over aquarium.
Bottom Holes = Suspends fixture ~5"over tank
Middle Holes = Suspends fixture ~6"over tank
Top Holes = Suspends fixture ~7"over tank
4.
If mounting height needs adjusted, unscrew the back tank mount
screws with a screwdriver.
Adjust bracket to the correct height
and reassemble.
5.
Loosen adjustment screws to fit over aquarium glass or frame.
DO
NOT CUT YOUR FRAME. If you require a larger bracket for a wide
frame tank, please contactus at [email protected].
6.
Place arm bracket on aquarium in desired location
and hand tighten
adjustment screws to fasten the arm bracket to tank. DO NOT
OVERTIGHTEN.
7.
Place light fixture clips with screw into slot of arm bracket
, then
tighten with turn nut. Front-to-back position can be adjusted using
turn nut and sliding light and clip to optimal position.
8.
When ready, slide light fixture into light clip
and position fixture to
optimal position. Route light cable behind tank arm mount and
follow fixture instructions.
IMPORTANT: Follow all safety instructions
included with each tank mount arm bracket.
Adjustable Tank Mount Arm Bracket Installation
LOOP® Marine Bundle Kit
A
B
Attach fixture by sliding
horizontally into fixture clip
1
Unpack components
5
Loosen adjustment screws
attach bracket to tank.
4
Adjust height
7
Attach fixture clips
8
Slide fixture into clips
Page 5
