4.
Install Velcro strip to bottom of surge protector.
Attach surge protector to bottom shelf on
Power Center, ensuring the cable is located in the right direction for easy plug in (determined
location and cable access location on stand.)
5.
Plug the four DC power supplies into surge protector.
6.
Install cable tie mounts to side panels
of power
center using the flat mounting screws and wing nuts.
There are 4 locations for the mounting the 2 included
cable tie mounts on the Power Center. These can be
used to wrap and organize excess cable from the LED
lights or wave pumps.
7.
Use the template below to pre-install the mounting
screws for the power center.
Use a pencil to mark
mounting holes - square 15" wide x 10-1/8 high.
Power Center Installation
LOOP® Marine Bundle Kit
P1
P3
P2
L1
L2
P1
P3
P2
L1
L2
15"
15"
10-1/8"
10-1/8"
8. Use a small drill and drill a small hole fr screw insertion.
CAUTION: Do not to drill through entire stand wall.
Using a small Phillips head screwdriver, install the four
wood mounting screws.Leave 1/4" of screw offset for
Power Center installation.
1/4" Offset
6
Install 2 cable
tie mounts
4
Install surge protector
using velcro
5
Plug power supplies
into surge protector
7
Mark mounting holes for power center
15" Wide x 10-1/8" High
8
Install screws and
leave 1/4" offset
Page 3
