Cuppone Giotto GT110, Pre-Installation And Installation Manual

Page: 37 / 42

Ed. 05421 - 70702561 - REV04 - valid from serial number 21052570 - Giotto - Installation
37
Installation
Pre-testing and final inspection
The oven is checked and tested in the Manufacturer’s plant
before being delivered to the customer.
The “production process check sheet” enclosed with it guar-
antees that
each step in the production process, from assem-
bly to packaging, was carefully checked from both the oper-
ating and safety standpoints.
After installing the appliance, check and mark with a “√” all the
boxes of the table on the side: this will confirm the installation
is complete and correct.
Finish off explaining to the user how to use the appliance in
an optimal and safe way and how to carry out ordinary main-
tenance and cleaning.
Checking the operation and first
start-up
Start the appliance following the instructions in the “Use and
Maintenance” manual annexed: monitor it during the whole
test and check that all the electrical components work properly.
The first time you use the oven, set the temperature at
150°C - 302°F, 80% percentage at the top, 20% in the bot-
tom for at least 8 hours, without placing any food inside.
During this time, keep the chimney flue fully open and the
hood, if present, ON.
In this first phase, because of the humidity evaporating from
the insulating materials, the oven will give out unpleasant
smells and fumes that will gradually disappear during the fol-
lowing operating cycles.
√ Positioning checks Reference chapter on page...
Is the installation room adequate and compliant with regulations? (correct ven-
tilation, maximum/minimum temperature, etc.)
Oven transport and positioning
on page
16
Is the appliance perfectly level?
Is the appliance resting on the base underneath and is this suitable to support
the weight of the oven?
have the minimum distances stated been complied with?
has the protective film been removed from the surfaces?
Preliminary operations
on page
17
Is the oven chamber free from non-compliant objects (e.g. Installation tools,
user manuals, packaging, etc.)? If so, remove them!
Is the current chimney flue adequate and does it comply with the current reg-
ulations?
Smoke extraction
on page
31
√ Electrical checks Reference chapter
Does the mains voltage match the data on the rating plate?
Electrical connection
on page
32
Do electric connections meet current regulations in the country of installation
and follow the diagrams supplied?
√ Smoke outlet checks Reference chapter
Is the appliance positioned correctly under a suitable hood?
We would like to remind you that it is possible to connect the smoke outlet to
an extractor (fan or extraction pipe of a motor-driven hood), putting in between
the latter and the oven chimney a switch.
Smoke extraction
on page
31
√ Miscellaneous Reference chapter
Does the user have all the documentation relative to the oven? -
has the user been correctly trained on the use and maintenance of the oven? -