M510-2
, page 3
Dehumidifier model NADER YARD PRO
Installation rules
Condensate drain pipe
The only installation required, for the dehumidifier to operate
correctly, is that of the condensate drain pipe: the condensate is
drained continuously through a connection on the right side of the
machine, as shown in Figure 1.
The drain pipe must be positioned so that the water may flow off:
there must not, therefore, be any obstacles along the way, the pipe
must not be kinked and must always have a certain slope, and, at
any rate, it must always be in a position lower than that of the
connection.
Figure 1 – Condensate drain pipe
Make sure that the water is drained regularly: if a bucket is used to collect the condensate it is
important to remember that it must be emptied regularly to avoid spilling.
Once the drainpipe has been installed, the dehumidifier has only to be placed in the room to be dehumidified
and then started up. For maximum efficiency, respect the following rules:
make sure that the room where the dehumidifier is to be placed in never exceeds the limit conditions
of operation of the machine (Table 1);
the room the dehumidifier is to be placed in must be closed;
the machine must always operate in a vertical position with the wheels facing downwards;
the dehumidifier must be placed in such a way as to leave the air inlet and outlet grids free (at least
10 cm of air space);
make sure that the power supply voltage corresponds to that indicated in Table 1 and that the electric
installation complies with the safety regulations in force;
it is advisable to put the dehumidifier in the coldest part of the room where the humidity normally
collects.
Positioning
The dehumidifier of the
N
ADER
Y
ARD PRO
series is fitted with two 250-mm diameter wheels that make it
easy to handle and move, even on rough surfaces: furthermore the handle can be fitted in two different
positions to better adapt to personal needs. If necessary, the machine can easily be lifted from the ground by
using the two handles fitted to it.
NEVER try to lift the machine off the ground by yourself: if it must be lifted there must be at
least two people to do it.
It is advisable to put the dehumidifier near a mains socket.
Start-up (B)
Insert the plug into the 230V, 50Hz grounded socket. Set the general switch (8) to position
I
. If a humidistat
(optional) is fitted, set the knob to the desired humidity value.
