Cumberland
1004 E. Illinois St.
Assumption,IL 62510
PHONE 1-217-226-4421
FAX 1-217-226-4420
Manual Part No. 4801-5323 Rev 1-2015 Page
1
of
12
MEGA
-FLOW CONE FAN
Fan & Cone Installation
When this fan is used in a life support ventilation
system where failure could result in loss or injury,
the user should provide adequate backup
ventilation, or accept the risk of such loss or injury.
IMPORTANT!
BEFORE INSTALLING
1. Inspect fan for damage in transit. Check for
loose, missing, or damaged parts.
2. If there are any missing parts or if there is
any shipping damage, do not attempt to
operate fan. Contact your Distributor.
MAINTENANCE
1. Read WARNING statements before proceeding.
2. Blades, motor, and wire guards should be
cleaned periodically to decrease vibration and
ensure maximum fan life. Remove dirt with a
dry brush or compressed air. DO NOT SPRAY
MOTOR WITH WATER OR CLEANING FLUIDS.
3. Fan performance may be greatly reduced by
damaged or dirty shutter. Clean and inspect
shutter periodically to ensure maximum fan
performance.
1. Fan should be securely mounted to wall. Refer
to mounting instructions on Section 4 of this
manual.
2. The cone and wire guard must always be
installed for your protection.
National safety codes require that guards be
installed if within 7 feet (2.1 m) of floor or within
reach of personnel or livestock.
3. If thermostat is used, connect fan power cord to
controller.
INSTALLATION
1. Disconnect power source before installing or
servicing fan. Failure to disconnect power
source can result in property damage,
serious injury, or death.
2. When connected to an automatic controller,
FAN MAY START AT ANY TIME.
3. IMPORTANT! Before Operating Fan, Inspect
Fan For any Object That May Obstruct Blade
Rotation.
!
WARNING!
