Cumberland
1004 E. Illinois St.
Assumption,IL 62510
PHONE 1-217-226-4421
FAX 1-217-226-4420
Manual Part No. 4801-5323 Rev 1-2015 Page
7
of
12
MEGA
-FLOW CON FAN
Fan & Cone Installation
6. Assemble Tab Cone
Cone Assembly Steps
a.
Lay cone panels on the ground as shown in
Figure 5
.
b.
Slip four (4) cone panels together using tab and slot connections on edges of each panel.
IMPORTANT:
All tabs must be on the inside of the cone assembly. The pilot holes and etched marks
(orientation indicators) must be located at the top and outside of the cone.
c.
Place bolts through holes and thread nuts into place to hold four (4) cone panels together. Nuts must be
located on the outside of the cone assembly. Do not tighten nuts. Refer to
Figures 6 & 8
.
d.
Once four (4) cone panels are assembled stand assembly up on large radius side. Refer to
Figure 5
.
e.
Pull both ends together creating a heart shape as shown in
Figure 7
.
f.
Place remaining bolts through holes and thread remaining nuts into place to hold cone together.
Nuts must be located on the outside of the cone assembly. Do not tighten nuts. Nuts are to be tightened
after cone is mounted on the fan. Refer to
Figure 8
.
Figure 5: Fan Cone Panels
WARNING!
During Cone Installation Be Sure That Fan Motor Is Not Plugged Into Any Power Source.
Always Double Check Power Sources.
!
Slits for Collapsible
Side Panel 54” Cone
Only
Nuts on the
Outside
IMPORTANT
All pilot holes and
etched cone sizes must
be located at top &
outside of cone
Figure 6: Cone Orientation Indicators
