- 8 -
The installation of electrical
wiring from the electricmeter,
main control box or service
outlet to the electrical
appliance. Qualified
installation personnel must be
familiar with all precautions
required and have complied
with all requirements of state
and local authorities having
jurisdiction. See: National
Electrical Code, ANSI/NFPA70.
The appliance individual
shutoff valve must be
disconnected from
the gas supply piping system
during any pressure testing
of that system at test
pressures in excess of 1/2psi
(3.45kPa).
For an oven equipped with
casters, the installation shall
be made with a
connector that complies with
the Standard for Connectors
for Movable Gas
Appliances, ANSI Z21.69/CSA
6.16 and a quick-disconnect
device that complies
with the Standard for Quick-
Disconnect Devices for Use
with Gas Fuel, ANSI
Z21.4/CSA6.9.When installing
the oven with casters and
quick-disconnect hose,
adequate means must be
provided to limit the
movement of the oven without
depending on the connector
and the quick disconnect
device or its associated
piping to limit the oven
movement. Restraining means
may be attached to the
vertical portion of the base
frame in the rear of the oven.
Unpacking and Installation
Please dispose of all packaging
materials and residues after
unpacking;
Check the equipment. If it
is damaged, please keep
wrappers and
receipts which must be signed
by the carrier representative
(Driver), and contact the
carriers to pursue a claim
within 15 days after receiving;
Be sure to install
supporting legs before using,
and do not tear up any label or
logo before normal using;
Please read these instructions
carefully before installation
and operation.
Mounting Stacking Bracket
1.
Install 4 pcs 5" castors or short legs to the baseplate of the bottom oven, as described
in the previous section.
2.
Put the oven on the upper layer to that on the lower layer and align the edges of all
ovens.
3.
Dismantle two existing screws on the rear lower part of the oven on the upper layer
and dismantle one existing screw on the rear upper part of the oven on the lower layer.
4.
Install the stacking bracket using the existing screws and those in the packaging bag.
5.
Repeat the steps and install the second stacking bracket on the other side.
1.
Take out the flue out of the packaging box and insert its upper part from bottom to top
into the opening at the rear upper part of the oven on the upper layer.
2.
Align the lower part of the flue with the opening of the baseplate at the rear lower part
of the oven on the upper layer.
3.
Align the hole on the flue with that on the rear plate of the oven on the upper layer
and fix it on the rear plate with 6 screws.
Mounting Flue Extension to Top Oven
Gas Fired Deep Depth
Convection
Oven
s
A Professional Line of Commercial Cooking Equipment
Summary of Contents for TEKCO1-LP
Page 24: ......
