23
kinked or trapped when the hob is in position. Care must be taken
to avoid the cable being in contact with hot parts of the appliance.
Replacing the mains supply cable
If the mains supply cable is damaged, then it must be replaced by an
appropriate replacement.
The mains supply cable should be replaced in accordance with the
instructions on the next page:
o
Switch the appliance off at the socket.
o
Open the terminal block on the underside of the hob.
o
Unscrew the terminal screws fixing the cable.
o
Replace the cable with one of the same length and in accordance
with the specification given on page 21.
o
The “green
-
yellow”
earth wire must be connected to the terminal
marked
. It must be about 10 mm longer than the live and
neutral wires.
o
The “blue”
neutral wire must be connected to the terminal
marked with letter (N) - the live wire must be connected to the
terminal marked with letter (L).
o
The cooking zones are not functioning or will not switch on.
*
It has been more than 1 minute since the appliance was switched on.
You should switch the appliance back on again, using the ON/OFF
button and then switch on a cooking zone.
*
Several cooking zone selection buttons have been pressed at once.
You should only try to switch on one cooking zone at once.
*
The safety cut out has been triggered. Press the ON/OFF button to
reset the hob.
My appliance isn’t working correctly
