20
o
IMPORTANT: There are ventilation holes around the outside
of the hob. YOU MUST ensure that these holes are not
blocked by the work top, when you put the hob into position
(see drawing opposite).
o
NOTE: Your appliance comes fitted with a sealing strip already
attached to the underside of the hob. This should not be removed
as it will prevent liquid or spillages from penetrating the
underneath of the hob.
o
IMPORTANT:
Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob
from the aperture in future, particularly if it needs to be serviced.
o
Carefully lower it into the aperture hole that you have cut out.
(A)
Bracket
(B)
Screw
(C)
Sealing strip
o
Place the clamp
(A)
over the holes that match the size of the
screws. There are one set of screw holes in each corner of the hob.
Slightly tighten a screw
(B)
through the clamp
(A)
so that the
clamp is attached to the hob, but so that you can still adjust the
position of it.
o
On the underneath of the hob, adjust the clamps into a position
that is suitable for your worktop. Then fully tighten the screws
o
(B)
to secure the hob into position.
