24
CUES Inc.
,
Currahee Cutter User Manual | CK902
CUES Inc.
,
Currahee Cutter User Manual | CK902
25
www.cuesinc.com
,
24
CUES Inc.
,
Currahee Cutter User Manual | CK902
CUES Inc.
,
Currahee Cutter User Manual | CK902
25
4
SYSTEM SETUP & INSTALLATION
a. Attach the air and water
hoses to the cutter.
8
8a
FUNCTIONAL CHECKOUT
It is important to perform this checkout prior to placing the Currahee Cutter in the pipe. The
checkout is designed to uncover possible functional problems while the cutter is still on the surface.
Check to make sure that all the equipment is connected as described in the Electrical & Physical
Connections section. Check for loose fasteners or other components.
Gamepad Checkout: The cutter is controlled by the gamepad. Refer to the Gamepad section for
control functions.
Perform the following functions:
1.
Make sure the cable and hose reel controllers are set to the OFF position.
2.
Power up the generator. Once the system is powered up, turn ON the K2 PCU and allow
it to boot up. Refer to the K2 Power Control Unit (PCU) section for setup instructions.
3.
Use the gamepad to switch between the (2) cameras to verify proper video. While set to
the cutting camera, pan the camera to verify operation and focus the camera on the cutting
bit. Verify that camera lights are functional and can be adjusted for brightness. Refer to
the Gamepad section for operational instructions.
4.
Verify that the gamepad is in Cutting Mode and use the gamepad to move the air motor
UP/DOWN and CCW/CW. Adjust the motor speeds, as required, via the gamepad controls.
If desired, change the motor directions as described in the K2 Power Control Unit (PCU)
section.
NOTE: The UP/DOWN and CCW/CW motors will not work when cutter is in
Driving Mode.
5.
Use the gamepad to move the cutter FWD/REV. Adjust motor speed as required via the
gamepad controls. If desired, change the motor directions. Set the cutter to Driving Mode to
verify operation and return to Cutting Mode..
6.
Press the Air/Water Enable pushbutton and use the gamepad to briefly turn ON the air and
water supplies to verify operation. Pan the camera past the wiper blades to clean the lens.
