www.cuesinc.com
,
14
CUES Inc.
,
Currahee Cutter User Manual | CK902
CUES Inc.
,
Currahee Cutter User Manual | CK902
15
3
EQUIPMENT OVERVIEW, CONTROLS & SETTINGS
K2 POWER CONTROL UNIT (PCU) - continued
B.
CONTROL SETTINGS
The K2 Customizable Parameters Screen contains assorted system settings (image below is for
reference only). The following are the settings that pertain to the CK600 Currahee Cutter.
===== CUES CUSTOMIZABLE PARAMETERS =====
LONG PAUSE TIME(msec): 2000
SHORT PAUSE TIME(msec): 200
SKIP EQUIPMENT SCREEN: NO
VIDEO FORMAT: NTSC
CUTTING UP/DN:NML CCW/CW:NML FWD/REV:NML
DRIVING FWD/REV:NML
SPEED UP/DN: 60 CCW/CW: 60 FWD/REV: 60
VIDEO ON POWER SUPPLY: NO
DISTANCE UNITS: FT.
SAMPLING METHOD: AVERAGE QUANTITY: 1
DUC CRUISE: DUC ONLY
CRUISE SPEED PERCENT: 58
SWAP JOYSTICKS: NO
MPT/uPT/CAW RECONNECT (msec): 5000
INCLINE THRU PRESSURE: NO
UP/DOWN to set normal reverse polarity
CUTTING/DRIVING
•
Select the polarity of the joystick movements independently for each cutter motor (UP/DN,
CCW/CW, and FWD/REV).
•
The settings in the “Cutting” row apply when operating the cutter in Cutting Mode, and the
settings in the “Driving” row apply when operating the cutter in Driving Mode.
•
Options:
NML “Normal” – the motors move in the default directions for this joystick axis.
REV
“Reversed” – the motors move in the opposite-of-default directions for this joystick axis.
SPEED
•
Select the motor speed independently for each cutter motor (UP/DN, CCW/CW, and FWD/REV).
•
The speed settings are percentages and they apply when operating the cutter in Cutting Mode.
For example, a value of “75” would result in that particular motor moving at 75% (of maximum)
speed during cutting operations.
========== CUES DISPLAY SET UP =========
FONTS: SMALL_OUT SCREEN TIMEOUT:None
MAIN DISTANCE: On RT FONT EBW 1, 1
LATERAL DISTANCE: ON HUMID:OFF 2, 1
TIME: On hh:mm AM 04:47 PM 3, 1
DATE: On MM/DD/YY 11/07/16 4, 1
PRESSURE:Off PSI ZERO? 5, 1
INCLINE:Off DEG. 5-DEGREE ZERO? 6, 1
TRANS SPEED:Off CUTTER SPD: ON 7, 1
TTL: Off 8, 1
MH-1: Off 9, 1
MH-2: 10, 1
DIR: Off 11, 1
LEN: Off 12, 1
CMT1: Off 13, 1
CMT2: 14, 1
ARROW UP/DOWN to view cutter speed list
NML
