Copyright Reserved HyVISION System Inc.
This document is Quick Start Guide (151001,En). To improve quality of product, this could be revised without
prior notification or consent.
HyVISION System is not liable for any losses resulted from the use of the document or any errors or offering
.
6
[E1] Filament insertion hole
Hole to insert the filament into the Extruder through Teflon tube.
[E2] Filament handle
Handle to manually pull the filament out of the extruder or insert it.
[E3] Mold fan
Fan to flow the air into the molded object.
[E4] Heated block cover
Cover case to surround the nozzle heated block. (heat-resisting rubber)
[E5] Nozzle
Nozzle to extrude the molten filament.
[E6] Extruder cable
Cable for power supply of Extruder and signal transfer
[E7] Cable fixing screw
Screw to fix the cable to the Extruder (m2.5)
[E8] Cable fixing block
Block to fix the cable to the Extruder.
[E9] Cool End fan
Fan to cool down the heated block.
[E10] Extruder module fixing screw
Fixing screw to separate the Extruder module.
[E11] Gear fan
Fan to cool down the gear of internal Extruder.
[E12] Extruder cover
Cover to check the internal Extruder
* Do not touch the nozzle of extruder being heated while printing.
* Varify if there is some obstacles under the extrder when opening the Extruder cover.
* Remove or mount the Extruder module when the nozzle temperature cools down and power
turns off.
Part of the Extruder
E5
E2
E1
E4
E3
E6
E7
E9
E8
E11
E10
E12