
Page
6
of
25
Insert the two support poles into the rear bow corners of the camper
•
Release the locking screw on the slide bracket (Numbered 3) just inside the zip door (this is the
fitting that secures the rear diagonal bar to the centre upright bar). Release the snap lock adjuster
(Number 2) on the doorway side of the rear tent bow to temporarily take the tension off, and then
raise the diagonal bar upwards until it reaches a horizontal position above the doorway.
Failure to
release the snap lock adjuster (Number 2) may result in damage to the bow poles.
Release snap lock adjuster (#2) before undoing locking screw (#3) and sliding bar upwards
•
Tighten the locking screw on the slide bracket to lock this bar in a horizontal position above the
doorway, and gently push the rear bow outwards (if it has slackened off), then re-tighten the tent
bow adjusting screw.
Slide bar upwards until horizontal & tighten locking screw
Refer to separate instructions on
page 10 for awning set-up.
Closing the Camper
•
Ensure that all lights/appliances are unplugged from the power source before the camperis closed.
Locking screw on slide
bracket 3
Summary of Contents for EXPLORER
