
Page
4
of
25
•
The roof/hard floor will begin to rise but will need some assistance in raising it to vertical - the white
stop line on the winch strap allows for the roof/hard floor to be raised to vertical only. The winch is
self-braking and will prevent the roof/hard floor from further opening.
(
It is important that the
winch strap winds on and off from the top of the winch spool, and NOT from under or the
bottom of the winch spool)
.
Lift the lid of the camper, the STOP on the winch strap will ensure that it only goes to 90°
•
Return to the winch and continue to wind out the roof/hard floor section until it reaches the ground,
then continue to unwind the winch ensuring the winch strap is quite loose at this point
(there
needs to be some slack in the strap to allow for the extension of the rear tent bow).
Continue to unwind until the roof/hard floor reaches the ground
•
The gap between the hard floor and the trailer body should be minimal and reasonably parallel. You
can now adjust the four (4) adjustable legs on the hard floor. The roof of the trailer has now become
the hard floor of the opened Cub.
Adjust the 4 legs on the hard floor using the blocks provided if surface is not level
•
Lift the canvas over the trailer body at the side where the trailer body angles downwards at
approximately 45 degrees, ensuring care is taken to raise the canvas above and over the weather
seal to avoid any unnecessary damage to the weather sealing of the trailer.
Summary of Contents for EXPLORER
