Cub EXPLORER, Instructions Manual, Page: 14 / 25

Page 14 of 25
GAP BETWEEN THE HARD FLOOR/ROOF SECTION AND THE TRAILER BODY IS
QUITE LARGE/WIDE AND CANNOT CLOSE THIS GAP.
•
Check the ground level, and if needed, adjust the floor/roof support legs to allow the floor/roof
section to be lowered down further. If the support legs cannot be shortened any further, then some
minor digging out of the ground where the legs meet the ground may be required. Is the trailer set
level? The trailer should be set up on reasonably even ground and should be set reasonably level.
•
Are the rear stabiliser legs on the camper trailer sinking into the ground (this may happen on soft or
sandy surfaces)? If so, tile size pieces of ply or similar should be used to prevent the stabiliser legs
sinking into the ground.
REAR TENT BOW DOES NOT EXTEND FULLY
•
Check that the winch strap has been extended to allow full extension of the rear tent bow when
setting up. This can be shortened or tightened after set up has been completed.
•
Check that the adjusting screws have been released.
•
Are you using sufficient force when pushing outwards on the rear tent bow? If the winch strap has
been sufficiently released, push outwards until the canvas stops you extending outward any further.
CAN’T CLOSE THE DOOR ZIP WITHOUT USE OF FORCE (DO NOT FORCE THE ZIP AS
THIS MAY RESULT IN DAMAGE TO THE ZIP WHICH IS EXPENSIVE TO REPAIR)
•
Look at the tent set up, is the front (draw bar end) of the tent sagging? Is there a large crease on the
side windows running from the tent bow junction up to the top of the tent bow at the draw bar end? If
yes to either of these questions, a full tent setting is recommended as follows:
Please call Explorer Camper Trailer Hire on
08 8278 5771 before attempting Reset.