Cub Cadet R72 Li 48 V1, Operator'S Manual

Page: 267 / 867

EN - 28
8.
The icon in fig. 7.E remains ON
and battery LEDs 1, 4 and 5 flash.
Current overload to cutting
means caused by:
1.
Work conditions too demanding. Reduce forward speed:
Increase the cutting height:
2. Obstructions that prevent
rotation of the cutting means.
Remove the obstructions.
3.
The cutting means
assembly is full of grass
Clean the cutting means assembly:
9. The icons in fig. 7.E and
fig. 7.O remain ON, battery
LEDs 1 and 3 flash.
Cutting means motor over-
temperature caused by:
Turn off the machine, wait for at
least 5 minutes and then restart it.
Work conditions too demanding. Reduce forward speed:
Increase the cutting height:
10.
The icon in fig. 7.E remains ON
and battery LEDs 1, 3 and 5 flash.
Cutting means motor stall caused by:
1.
Work conditions too demanding. Reduce forward speed:
Increase the cutting height:
2. Obstructions that prevent
rotation of the cutting means.
Remove the obstructions.
3.
The cutting means
assembly is full of grass
Clean the cutting means assembly:
11.
The icons in fig. 7.E and
fig. 7.O remain ON, battery
LEDs 1, 2 and 4 flash.
Drive motor over-
temperature caused by.
Switch off the machine and wait
for at least 5 minutes before
repeating the starting procedure.
1.
Drive motor under stress. Reduce forward speed:
2. Slope too steep .
Reduce speed and check the slope
of the ground where you are working.
3.
Excessive mud on the wheels. Make sure that the wheels are not
blocked and clean as needed.
12.
The icons in fig. 7.E and fig. 7.O
remain ON, battery LEDs 1, 2, 4
and 5 flash.
The machine starts with the
drive pedal not released
(not in neutral position).
Switch off the machine and
repeat the starting procedure
only after having checked that
the drive pedal is in the neutral
position (pedal released).
13.
The icons in fig. 7.E and
fig. 7.O remain ON, battery
LEDs 1, 2, 3 and 5 flash.
Drive engagement/disengagement
lever in drive disengaged position.
Check the position of the drive
engagement/disengagement
lever and, if necessary, return it
to the drive engaged position.
If the problem persists,
contact a Service Centre.
14.
The icon in fig. 7.E remains
ON and battery LED 2 flashes.
Battery detection/
communication error
Switch off the machine and
repeat the starting procedure
Check the correct mounting/
installation of the batteries
in their respective slots.
If the problem persists,
contact a Service Centre.