32
s
ectiOn
6— M
aintenance
& a
djustMents
Adjust the eyebolt at the left front of the deck so that the
4.
blade-to-ground height at the right front blade tip matches
that of the left front blade tip. This is done by loosening the
jam nuts on the eyebolt and tightening the upper nut to
raise the deck and loosening the nut to lower the deck. The
right front blade tip height is fixed so you must adjust the
left front tip to match it. See Fig. 6-6.
Once the proper adjustment is made, re-tighten the lower
5.
jam nut.
Front to Back Leveling
Measure the blade-to-ground height at the right rear blade
1.
tip. Again be sure to measure at the blade tip at the rear of
the right blade when aligned along the mower centerline.
The blade-to-ground height at the rear of the blade tip
should be 1⁄8” to 1⁄4” higher than the front tip. This is referred
to as blade pitch. The same height difference should be
true for the left blade, measured front and back. The pitch
should not exceed 1⁄16
” if cut height is below 1-
1⁄2”.
Loosen the inner jam nuts at the rear left and right of the
2.
horizontal threaded rods. See Fig. 6-7.
Removing The Tractor From Storage
Check the battery. Charge if necessary.
1.
Lower tractor off blocks, and inflate the tires to the
2.
recommended pressure.
Remove the spark plugs and wipe them off. Using the
3.
starter, crank the engine to pump the excess oil out of the
spark plug holes. Replace the spark plugs and the ignition
leads.
If drained before storing, fill the fuel tank with clean, fresh
4.
gasoline.
Check the level of the engine oil in the crankcase and the
5.
hydraulic reservoir tank.
Start the engine and allow to idle for a few minutes to
6.
ensure engine is operating properly.
Drive the tractor without a load to make certain all the
7.
tractor systems are functioning properly.
Adjustments
Adjusting the Seat
Refer to the Assembly & Set-Up section for instructions on
adjusting the seat.
Adjusting the Steering Wheel
Refer to the Assembly & Set-Up section for instructions on
adjusting the steering wheel.
Leveling the Mower Deck
When correctly adjusted the mower deck should be level side to
side, and the front of the deck should be approximately 1⁄4” lower
than the rear of deck.
NOTE:
Check the tractor’s tire pressure before performing any
deck leveling adjustments. See the tire side wall for proper
inflation pressures.
Side to Side Leveling
Park the mower on a flat paved surface, engage the
1.
parking brake, shut off the engine, remove the key from the
ignition switch, disconnect the spark plug wires and using
the power implement lift, position the mowing deck into
the 4” height of cut position. (The 4” height of cut position
is recommended in order for one to see and obtain a
measurement. Any height of cut position is acceptable as
long as a proper measurement can be taken.)
Measure blade-to-ground height at the front tip of the
2.
right blade. To obtain an accurate measure, align blades in
parallel with mower centerline, (i.e. front to back).
Measure blade-to-ground height at the front tip of the left
3.
blade. Be sure to measure at the blade tip with the blades
arranged in proper position.
Left Front of the Deck
Eye Bolt
Upper
Jam Nut
Lower Jam Nut
Figure 6-6
Inner
Jam Nut
Outer
Jam Nut
Horizontal
Threaded Rod
Figure 6-7
Summary of Contents for S6031 Tank S
Page 45: ...Notes 12 45...
