41
Interface Command
Parameter Description
MCT-RACK(config-slot-slot-slot-
if-port-port)# duplex [full]
[full]
Configure port duplex to
full.
No command
MCT-RACK(config-slot-slot-slot-
if-port-port)# no duplex
Set the selected ports’ duplex mode to the
default setting.
Note :
Auto-negotiation needs to be
disabled before configuring duplex mode.
3. Qos configuration
Interface Command
Parameter Description
MCT-RACK(config-slot-slot-slot-
if-port-port)# qos rate-limit
ingress [0|32-1000000]
[0|32-
1000000]
Configure
ingress
rate limit, set zero or
from 32Kbps to 1000Mbps.
MCT-RACK(config-slot-slot-slot-
if-port-port)# qos rate-limit
egress [0|32-1000000]
[0|32-
1000000]
Configure
egress
rate limit, set zero or
from 32Kbps to 1000Mbps.
No command
MCT-RACK(config-slot-slot-slot-
if-port-port)# no qos rate-limit
ingress
Undo
ingress
rate limit.
MCT-RACK(config-slot-slot-slot-
if-port-port)# no qos rate-limit
egress
Undo
egress
rate limit.
4. Shutdown interface
Interface Command
Parameter Description
MCT-RACK(config-slot-slot-slot-
if-port-port)# shutdown
Administratively disable the selected
ports’ status.
No command
MCT-RACK(config-slot-slot-slot-
if-port-port)# no shutdown
Administratively enable the selected ports’
status.
5. Speed configuration
Command
Parameter Description
MCT-RACK(config-slot-slot-slot-
if-port-port)# speed [1000 |100 |
10 | auto_sense]
[1000 |100 |
10 |
auto_sense]
Set up the selected interfaces’ speed.
Manual speed configuration only works
when “no auto-negotiation” command is
issued.
No command
MCT-RACK(config-slot-slot-slot-if-port-port)#
no speed
Set the selected ports’ speed to the
default setting.