46
1048576] kbps
kbps
Gateway(config-if-PORT-PORT)#
qos rate-limit egress [port | queue]
[port | queue] Configure egress rate mode
Gateway(config-if-PORT-PORT)#
qos user-priority [0-7]
[0-7]
Specify the default priority bit to the
selected interfaces.
No command
Gateway(config-if-PORT-PORT)# no qos default-
class
Undo default queue on the port
Gateway(config-if-PORT-PORT)# no qos rate-limit
ingress
Delete QoS ingress rate limit
setting.
Gateway(config-if-PORT-PORT)# no qos rate-limit
egress
Delete QoS egress rate limit setting.
Gateway(config-if-PORT-PORT)# no qos user-
priority
Set the user priority value setting
back to the factory default.
2.5.12 Security Command
1. General Settings
Command
Parameter
Description
Gateway(config)# security
firewall
Enable Firewall function.
No Command
Gateway(config)# no
security firewall
Disable Firewall function.
Show Command
Gateway(config)# show
security firewall
Shows the current status of firewall.
2. Set up Packet Filter
Command
Parameter
Description
Gateway(config)# security
packet-filter
Enable the packet filter function. When it
is enabled, the Residential Gateway will
drop packets which meet predetermined
conditions of the rules in the following
commands.
Gateway(config)# security
packet-filter apply
Apply all the configured packet filter
settings made.
Gateway(config)# security
packet-filter application [1-
10]
[1-10]
Specify the entry number of application
packet filter. This allows you to edit the
table of application filter rules. The
Residential Gateway will drop packets
when it receives packets which match the
entries in the rule table.
Gateway(config-
application-No.)# active
Enable the specified application filter rule.
Gateway(config-
application-No.)#
[1-11]
Specify an application whose packets will
be denied by this filter rule.