7
Installation - Sensor
2. Fitting the sensor
NB:
If testing the sensor prior to mounting, the sensor must be placed in the fixing bracket
so as not to activate the anti-tamper function. mKomfy 1.8 sensor f.o.m. snr: 2024-000001
has a new fixing bracket (with lug) which is not compatible with the previous version.
1. Remove the battery cover and fit batteries (3 x AA).
2 beeps = battery OK.
2. Tear off the red protective film on the bracket.
Mount the sensor on a flat, clean surface on the wall above the
centre of the cooker at a height of 45-55 cm, see figure 2. For other
installation heights, see page 9.
NB: If the material on the wall surface is unsuitable for mounting with
tape, a screw must be used in the centre of the bracket foot.
3. Press the control button on the sensor once. A short beep confirms
that the sensor is in communication with the socket and working.
If there is no beep, check that the sensor has been correctly mounted
in the fixing bracket (anti-tamper function).
4. Make sure that only the green LED on the socket lights up when the
cooker is connected and turned off. If the yellow LED lights up, the
cooker’s standby electricity consumption is higher than the standard
setting. In this case the level in the mKomfy can be calibrated to the
cooker’s actual electricity consumption, see pages 10 and 11.
*
*
45 til 70 cm
30 cm
60 cm
60 cm
30 cm
Senter komfyrvakt
Senter komfyr
figure 2
sensor height 45-75 cm for hobs <= 60 cm wide
sensor height 65-70 cm for hobs <= 90 cm wide
Centre of Cooker Guard
Centre of cooker
6
Installation – Socket
1. Fitting the socket (may
only be carried out by
authorised personnel)
1. Connect and fit the
socket.
2. Connect the cooker
plug to the Cooker
Guard’s socket.
3. Check that power
is connected to the
socket.
DO NOT CONNECT!
If there is no radio communication from the sensor, the plug will shut off after 5 minutes.
The sensor and socket are paired at the factory and ready to install.
If re-pairing is necessary:
Remove at least once battery from the sensor (you can get batteries ready for
the sensor, but DO NOT fit them).
1.
Give the Socket control button a quick press. Yellow LED flashes.
2. Hold the control button on the sensor in and fit batteries in the sensor.
3. There are 4 beeps, the blue LED on the socket flashes and the socket
turns off.
4. Release the control button on the sensor.
The sensor and socket are now paired.
Status LEDs
Green
lights up
when socket is ON
Blue
flashes
when data is received from paired units (e.g. sensor)
Blue +
Green
flash
alternately
1 minute after emergency mode* is activated, and continues
to flash while the product is in emergency mode (12 hours).
Red
flashes
if socket overheats – socket is turned OFF
Red
f
beeping
if there is an error, e.g. external switch paired before
sensor
Yellow lights up
when cooker’s electricity consumption exceeds 1.2 A
**
Yellow flashes
in pairing mode
*
emergency mode = all safety functions deactivated. See page 5.
**
1.2 A is the factory default. After calibration, the LED lights up when the new setting is
exceeded (page 11)
Control button
