CTD CM325R, Instruction Bulletin & Maintenance Manual, Page: 4 / 34

-4-
Diagram “A”
Assembly of Tables to Floor Stand:
1. Assemble leg to table with 3/8-16 bolts and nuts provided. Turn table upside down and attach leg to table
with leg rising vertically.
Note:
The hole in the table (when mounted properly) should be toward the back
of the table and at the far end from the blade to attach Fence Support Angle, P/N BF16 (see Diagram “A”).
2. Attach Table, P/N BF17 to machine floor stand on Angle Bracket, P/N BF05C. Use 3/8-16 bolts and
nuts provided on angle bracket.
Blade Installation:
Before setting blades on spindle,
always shut off or disconnect air supply
. With Motor OFF and Power
Disconnected , rotate Lower Blade Guard (p/n 200A270) up into Main Blade Guard (p/n 200A26L or R). Slide
link puller (p/n 200M320) off puller screw and bushing through large hole on slot. Remove four machine nuts on
Blade Guard Cover (200F250L or R). The entire Lower Blade Guard Cover Assembly (p/n 200E250L or R)
comes off as one piece, exposing spindle nut and flange. (Refer to Diagram “D” on Page No. 5.).
Attaching Extended Fence Gage:
1. Place Extended Fence Gage (5/8 x 2” material) on table. Bolt to fence bracket with screws provided.
Adjust fence gage so measurement rule is correctly set:
A. With a scale or ruler touching the side of the tips of the blade, measure a distance away from blade.
Be sure the ruler and the tape on the fence gage read the same. This may be visually deceiving. Use
a 90
°
square to check.
B. Adjust fence, left to right, as necessary.
C. Both fences, left and right, must be in perfect alignment. Use a long straight edge for this purpose
(see Diagram “D” & “E”).
D. Attach fence support angle to fence and table.
Diagram “B”
BF225 12’