CTD CM325R, Instruction Bulletin & Maintenance Manual, Page: 3 / 34

Installation and Set Up:
The CTD saw you have purchased is designed to cut wood, aluminum, plastic and steel, with, of course, the
proper blade and conditions. For the material you are cutting, please refer to the cutting instructions for each
material type. The 200R Series machines use a NEMA 56 Frame 2 H.P., 3450 RPM, 60 Hertz TEFC Motor.
CTD uses a speed-up so that the blade will run at approximately 11,000 SFPM on a 12” blade.
IMPORTANT:
Before operating saw, please be sure to read the “SAFETY INSTRUCTIONS TO THE
OPERATOR” (see Page No. 7).
Note:
The floor stand must be shimmed, leveled and bolted to the floor, or framed in to eliminate vibration.
Use holes provided in bottom of floor stand. All machines have been completely assembled at the factory,
then disassembled for shipment.
Assembly of Floor Stand, Support Tables and Measuring Gages:
Standard Machine—The standard model has been completely assembled. Fences are set at the centerline
of the blade (see Diagram “D” on Page No. 5). Adjust fences forward if necessary for your particular material.
The machine base must be level. The incoming material and outgoing material must lay flat on the machine
base (see Diagram “F” on Page No. 10).
Floor Stand Model—The 200R and 300R Series base is attached to the Floor Stand by means of three hex cap
screws bolted from the bottom of the base. The Floor Stand must be shimmed and leveled, and, if necessary,
bolted to the floor to eliminate vibration. The F255R is attached with (2) socket cap screws from the top in front,
and (1) hex cap screw from the bottom in the rear.
Space Requirements
-3-
Pneumatic Requirements: (if applicable) 1 CFM per 10 strokes at 75 PSI (.043 cubic meters at 5.4 kg/cm
2
)
Dust Collection Requirements: 800 CFM at 2” outlets
Cutting Tool Requirements:
Wide,
heavy, rigid plate 12” blades: .100 to .110 plate