CTC Union 588600001, Installation And Maintenance Manual

Page: 7 / 36

7
CTC EcoPart 600M
Checklist
The checklist must always be completed by the installation engineer
• If service is needed, you may be required to provide this document.
• Installation must always be carried out according to the installation and maintenance instructions
• Installation must always be carried out in a professional manner
Following installation, the unit must be inspected and functional checks performed as
indicated below:
Pipe installation
†
Heat pump filled, positioned and adjusted in the correct manner according to the instructions.
†
The heat pump is positioned so that it can be serviced
†
Capacity of the charge/radiator pump (depending on type of system) for the flow required.
†
Open radiator valves (depending on type of system) and other relevant valves.
†
Tightness test
†
Bleed the system
†
Check proper operation of the requisite safety valves
†
Requisite waste pipes connected to the floor drain (depending on type of system).
Electrical installation
†
Power switch
†
Correct tight wiring
†
Requisite sensors fitted
†
Accessories
Customer information (adapted to the relevant installation)
†
Start-up with customer/installer
†
Menus/controls for selected system
†
Installation and maintenance manual supplied to the customer
†
Check and filling, heating circuit
†
Information on fine adjustments
†
Alarm information
†
Functional test of safety valves fitted
†
Information on procedures for fault registration
______________________________________ ______________________________________
Date/Customer Date/Installer