Crystal Vision
Appendix
SW803 3G User Manual R1.4
35
01/09/2016
Multiple routing
Multiple routing can be performed by creating the required destination-source pairs
before pressing the TAKE button. The destination buttons will flash to show that they
have routing waiting for a take. To confirm the routing press the TAKE button and the
selected routing assignments will all be updated simultaneously.
This is similar to establishing a single crosspoint except that instead of pressing TAKE
immediately, further destination-source pairs are created first.
Note:
The last destination button pressed does not flash.
Setting up multiple routing:
•
Press the destination and then the source for each crosspoint assignment
required in turn – destination buttons flash
•
Press TAKE to confirm the routing
Using macros
Up to sixteen macros may be recorded and stored and recalled from the SW803 3G,
Statesman, and card edge control or by external GPIs. Unlike presets, salvos do not store
board setup data, switching mode or reference selection.
Macros can be created from the controller panel; by setting up multiple routing and
pressing SAVE instead of TAKE. All the source and destination buttons will flash to
indicate that a memory location needs to be selected. The source buttons 1 – 8 represent
macros 1 – 8, and the destination buttons represent macros 9 – 15. Select a memory
location and then press SAVE to confirm.
Creating a macro:
•
Set up the required routing
•
Press SAVE – all source and destination buttons flash
•
Choose a source/destination button for the salvo - SAVE will flash
•
Press SAVE to confirm the choice
To recall a macro press RECALL, select a memory location and then press RECALL
again to confirm, or any other button to cancel.
Recalling a macro:
•
Press RECALL – all source and destination buttons flash
•
Choose a source/destination button with a previously saved macro - RECALL
will flash
•
Press RECALL to confirm the choice
Notes:
When recalling macros only those crosspoints in the macro are changed. All other
crosspoints will remain as they were before the macro was recalled.
The operation of the panel described here is based on panel software version 4.01.