Crystal Vision Indigo SW803 3G, User Manual, Page: 23 / 36

Crystal Vision Using the front control panel
SW803 3G User Manual R1.4
22
01/09/2016
the desired assignment can be made. Navigate to the Macro Save menu and select a
location where the macro is to be saved. Save the macro.
To recall a macro enter the Recall Macro menu and select the desired location 1-15. Press
the F4 button to action the recall.
Tip:
If necessary view the routing table to confirm that the required connections have been set.
Note:
When reassigning routing, it is not necessary to disturb the existing routing. This is achieved
by leaving the new routing unasserted. See Routing.
GPI control
The SW803 3G may be controlled via GPI lines connected to the rear of the frame in
which the module is used. GPI control is limited to recalling stored presets or macros.
GPI control cannot be used at the same time as the SW808 Controller panel as both use
the same physical control lines. Please refer to the Installation chapter for more
information on using GPIs.
To enable GPI control select GPI Enable and set to ON.
The Reset menu
Pressing button F4 from the Home menu will enter the Reset menu.
Menu Comment
Factory Reset
Rotate the shaft control to view the Reset menu.
Press F2 to select Reset
Press F3 to action reset
Factory Defaults Rotate the shaft control to view the Default menu.
Press F2 to select Load defaults
Press F3 to action.
Note: Factory reset will erase all saved preset and macro configurations. To preserve contents
of the preset and macro locations use the Defaults command.
Parameter Default value
Routing
Input 1 to Output 1, Input 2 to Output 2, Input 3 to Output 3
Switch Synchronisation Field
Reference Input 1
Presets
Erased (factory reset only)
Macros Erased (factory reset only)
GPI Enable Not enabled