Crystal Vision Indigo SW803 3G, User Manual, Page: 22 / 36

Crystal Vision Using the front control panel
SW803 3G User Manual R1.4
21
01/09/2016
The Presets menu
From the Home press F3 to display the Presets menu and rotate shaft control to show the
available options.
Menu Comment
Save and recall
presets
Rotate the shaft control to view the Presets menu and press F2
Press F1 and rotate the shaft control to select location number.
Press F3 to save the board configuration to the selected location.
Press F4 to recall the saved configuration from the selected location.
Macro Record
Rotate the shaft control to view the Macro Record menu.
Press F2 to enter and press F3 to set the start point.
Press the up arrow [
] and make the required routing selections and
follow by a Macro Save .
Save and record
Macros
Rotate the shaft control to view the Macros menu and press F2
Press F1 and rotate the shaft control to select location number.
Press F3 to save the macro to the selected location.
Press F4 to recall the saved macro from the selected location.
GPI Enable
Rotate the shaft control to view the GPI Enable menu.
Press F2 to select.
On, Off.
Saving and recalling presets
Unlike a macro, a preset is a snapshot of the state of every crosspoint. Up to fifteen
presets can be saved and recalled at any time.
To save a snapshot of all crosspoint assignments as a preset press F2 to enter the Save
Presets menu, press F1 and rotate the shaft control to select the desired location 1-15.
Press F3 to save the current board configuration to the selected location.
Note:
Any previously saved crosspoint assignment in a location will be overwritten by the new
configuration.
To recall a preset again select the location of the preset you wish to recall and press F4 to
recall the stored board configuration.
Tip:
If necessary view the routing table to confirm that the required connections have been set.
Saving and recalling macros
A macro is a batch of crosspoint assignments, which are changed together and unlike a
preset will only affect that batch of crosspoints, any crosspoints outside of the batch will
remain unaffected when the macro is recalled.
To build a macro select the Macro Record menu and press the F2 button to enter. Press F3
to set the record point. Press the up arrow [
] and navigate to the routing menus where