Crystal Vision
Using the front panel
DEC104S User Manual R1.0
17
29/10/04
If remote control has been enabled, the control panel will then enter card mode and
communicate with the DEC104S at the node number last displayed in the available cards
list.
The DEC104S home menu
Updating the display
The values displayed on an active front panel are only updated when an adjustment is
made and when changing menu level. If mode changes occur through the use of
Statesman, card edge controls or through automatic response to the input video signal, the
text displayed on the active front panel will not be updated immediately. If necessary,
press CAL to update the display.
The DEC104S menu structure
The main top-level menus are obtained by pressing the F1, F2 and F4 keys from the
HOME menu. Menu keys are illuminated when active and when further menus are
available. The three top-level menus are:
CONF (Configuration) – press F1
LEVEL (Level adjustment) – press F2
TIME (Input/output timing and phase) – press F4
The following chart shows the available DEC104S menus. The actual menus available
may vary slightly as software is updated.
The DEC104S menu tree
4
1.00
