CRYSTAL MARK SWAM-BLASTER LV-1, Operating And Maintenance Manual

Page: 15 / 51

Section IV Page 4
4.3 PERIODIC SERVICE
A. PERIODIC INSPECTION.
The unit should be inspected periodically for:
1) Damaged Auxiliary Chamber Top Cover and cover seat on chamber Top
Plate.
2) Worn or damaged hoses.
3) Damaged wire insulation.
4) Loose wire or hose connections
5) Burned out indicator lamps.
6) Proper operation of controls and gauges
7) Worn nozzle.
B. PERIODIC CLEANING.
The unit should be periodically cleaned as follows:
1) Clean out dust and spilled powder from the unit's interior using low-
pressure compressed air or vacuum from the dust collector. Remove
stubborn dirt with a brush. Do not use cleaning fluid on the hoses or wire
insulation.
2) Clean the units external surface with cloth moistened with a detergent-
based solution.
4.4 COMPONENT MAINTENANCE
Unless specified in the component maintenance instructions, special instructions
are not required to remove or replace components of the unit. Use the component
assembly drawings in Section 5 for reference.
CAUTION!!
Prior to performing any maintenance on the unit, turn the unit “OFF”
and allow the systems air pressure to bleed off a minimum of 20
seconds.
When replacing worn, damaged or defective components use only components
supplied by
CRYSTAL MARK
or equivalent components approved for use by
CRYSTAL MARK, INC.
Replacement electrical wire and terminals as well as
pneumatic tubing and fittings must also be of the correct style, shape and usage
ratings. For additional information and assistance in obtaining replacement
components contact
CRYSTAL MARK, INC.