Crysalli Beverage Systems
a division of WPD
1739 Sabre Street, Hayward, CA 94545
www.crysalli.com
510.732.0100
CR-LBS10JG Kit
Leak block control unit sensor
Solenoid latch valve
9V battery
John Guest fittings
Operating Instructions
Installation:
1. Install the 3/8” fittings to the
solenoid valve inlet and outlet
ends. The thread of solenoid
valve is 1/2” BSP male. Then
connect a 3/8” OD tube from
the angle stop to the inlet fitting
on the solenoid valve (indicated
by position of the arrow). Then
connect a 3/8” OD tube from
the outlet end of the solenoid
to the water treatment system
that is feeding your Crysalli
CP2000 unit.
2. Put the 9V battery in the
control unit and activate it by
holding the check/reset button
for 4 seconds (see operation
instructions for more details).
3. Place the control unit next
to your Crysalli unit, ideally
between the filter system and
chiller.
4. Turn on water and check for
leaks at your connection points.
Operation:
1. Reset to work
a) Keep pressing button for
4 seconds, the control unit
activates solenoid valve to
open the inlet tube of water
treatment system, and
generates a long beep sound.
2. Auto shut-off when water leak is
detected.
a) The control unit shuts
activate solenoid valve to shut
off the inlet tube of the water
treatment system to block
water flow, and generates an
acoustic signal, “beep-beep,”
and blinks the blue light
continuously to notify the
water leak is detected. After the
leakage problem is solved, keep
pressing button for 4 seconds,
the control unit activates
solenoid valve to open the inlet
tube of water treatment system
again with a long beep sound.
3. Low power shut-off
a) When the battery power
is low, the control unit shuts
off the inlet tube of the water
treatment system, blinks red
light and generates an acoustic
signal “beep” to notify that the
battery needs to be replaced
to keep water leak protection
functional.
