1. Carefully remove unit from
packaging and locate drip pan,
water filter, 3/8” hose and angle
stop adaptor fitting.
2. Place the unit on the counter
and attach drip tray.
3. Remove the 2FC filter from its
packaging and insert into filter
head on back of unit. Push up
and twist to lift.
4. If water and electrical
connections are in the cabinet,
a 1” hole should be prepared in
the countertop.
5. They will come with an angle
stop adaptor that replaces the
compression nut and ring on
a standard 3/8 angle stop, it is
simply hand tightened on, then
an end of 3/8” hose is pushed
into it. Pull on hose to confirm
it is locked in.
6. Run hose to Crysalli unit and
push hose end into 3/8” fitting
at the water filter.
7. Ease water on at angle stop and
check for leaks at connection
points.
8. Plug unit in.
9. Remove lid of unit and fill the
water bath with 1 gallon of non
filtered water or until water
level is just below the white
overflow stand pipe. If water
bath is over filled water will
begin to drain out condensate
spout into drain pan. Water
will flow till level is at or below
white overflow stand pipe.
10. Turn the unit on. Full ice
bank formation for cold temp
dispensing will take 1 to 2
hours.
11. With a pitcher in hand and
under the faucet, pull handle
forward, or push and hold LED
push button to dispense, flush
at least two pitchers worth of
water through the system to
remove air from the system and
flush filter.
12. For push button (PB) models,
flow rate can be adjusted via
the pin on the valve. Remove lid
to access. Use a small flat head
screw driver adjust. Right turns
slows/restricts flow, left turn
opens for faster flow.
Crysalli Beverage Systems
a division of WPD
1739 Sabre Street, Hayward, CA 94545
www.crysalli.com
510.732.0100
located at the top of the valve.
Remove the lid to access the valve
and use a small flat head screw
driver to turn the pin.
As the unit runs it will create heat,
585 BTU per hour (as a reference,
1 burning match creates 1 BTU,
so image heat from 585 matches
warming a space), so there should
be enough space surrounding
the chiller to insure adequate air
circulating through the refrigeration
condenser. Do not block any of the
vented panels on chiller.
Water quality will also have an
influence on the water pressure.
The 2FC water filter will stop
particulates such as dirt and rust
as small as ½ micron in size as it
removes off taste, odors, colors
and cholerine from the water.
In this filtration process those
containments build inside the filter
cartridge and eventually plug the
water filter, resulting in dwindling
water flow. A Plug water filter is an
indication it is working, and that it
is time to replace it.
Water shut off valve/angle stop
and dedicate 120 volt power
outlet should be located as
near the chiller as possible in
order to facilitated install and
service. Position the Chiller so the
condenser coil vent panel is closest
to fresh air or the door of the
cabinet.
CP-JR-CT1SW Quick
Installation Guide
Instructions
