Crye Precision AIRFRAME, Operator'S Manual

Page: 2 / 20

THIS MANUAL MUST BE CAREFULLY READ BY ALL PERSONS WHO HAVE OR WILL HAVE
THE RESPONSIBILITY FOR USING OR MAINTAINING THIS PRODUCT. FAILURE TO USE AND
MAINTAIN THE PRODUCT ACCORDING TO ITS INSTRUCTIONS MAY RESULT IN THE PRODUCT
FAILING TO PERFORM AS DESIGNED, AND/OR THE PERSONS RELYING ON THIS HELMET
SUSTAINING SERIOUS PERSONAL INJURY AND/OR DEATH.
Any warranties made by Crye Precision LLC with respect to this product are voided if the product is
not used and maintained in accordance with the instructions in this manual. For any questions relative
to the use or repair of this product, please write Crye Precision LLC or call 1-718-246-3838 during
regular business hours.
WARNINGS
The following are general safety warnings intended to call attention to fundamental performance
limitations and areas of the helmet where proper usage must be followed. Failure to adhere to the below
instructions and warnings could result in serious personal injury or death to the wearer.
ƒ
This helmet is designed to protect the wearer against a specific range of projectile threats while
benefitting from a minimal overall weight. This protection does have its limits and will not protect
the wearer against all threats. Certain threats may exceed the helmets capabilities and cause serious
injury including severe brain damage and death. Refer to helmet specifications for performance
related data.
ƒ
It is important to note that certain regions of the helmet provide less protection than others.
Specifically, this helmet shell is not intended to protect against impacts that occur within 1 inch of
any peripheral edges.
ƒ
Inspect the helmet before and after EACH use. Do not alter the helmet in any way.
ƒ
This helmet is not to be relied upon to protect the wearer from falls from motor vehicles or bicycles,
or for similar activities.
ƒ
Fit problems, such as excessive tightness, should be corrected by adjusting helmet pad locations as
instructed in this manual and by ensuring that the appropriate helmet shell size is being used.
ƒ
All replacement parts should be acquired from Crye Precision or a licensed distributor.
ƒ
The most current version of this manual may be found at www.cryeprecision.com.